富营养化水体中黑水团的吸收及反射特性分析

对黑水团水体光学特性进行研究,是利用遥感技术监测和评估黑水团事件的前提.针对2015年7月在太湖发生的黑水团现象,采集了太湖黑水团区(区域一)、蓝藻水华区(区域二)、清水区(区域三)共36个水样,对这3个区域的水体遥感反射率以及吸收特性进行对比分析.结果表明:1区域一水体的总颗粒物、色素颗粒物和非色素颗粒物吸收系数比区域二、区域三高出1~2倍,在400~500 nm之间,区域一CDOM吸收系数相比另外两个区域的水体高出2倍左右.导致黑水团区域水体具有很低的遥感反射率,被人眼感知时呈现为黑色;2黑水团区域水体M值低于滇池、巢湖和太湖的M值变化范围,说明黑水团中CDOM的腐殖酸含量较高.此外,叶绿素a浓度与CDOM在350 nm处吸收系数之间具有很好的相关性,表明蓝藻的降解可能是黑水团中CDOM的一个主要来源;3在380 nm之后,黑水团区域的水体总吸收以色素颗粒物占主导,但在短波350~380 nm处,CDOM对总吸收的贡献率高于色素颗粒物和非色素颗粒物.     

羟基磷灰石-四氧化三铁-沸石复合材料制备及去除水中刚果红研究

采用可溶性磷酸盐、钙离子、二价铁离子、三价铁离子和天然沸石等材料制备了羟基磷灰石-四氧化三铁-沸石(HAPFe3O4-沸石)复合材料,对该复合材料进行了表征,并考察了该复合材料对水中刚果红的吸附作用.结果表明,HAP-Fe3O4-沸石复合材料对水中的刚果红具备良好的吸附能力.当pH由3增加到4或由7增加到11时,HAP-Fe3O4-沸石复合材料对水中刚果红的去除能力下降;当pH由4增加到7时,对刚果红的吸附能力基本保持不变.HAP-Fe3O4-沸石复合材料对水中刚果红的去除率随吸附剂投加量的增加而增加,而对水中刚果红的单位吸附量则随吸附剂投加量的增加而降低.HAP-Fe3O4-沸石复合材料对水中刚果红的吸附动力学过程可以较好地采用准二级动力学模型加以描述,对刚果红的吸附平衡数据可以采用Langmuir和Freundlich等温吸附模型加以描述.根据Langmuir模型确定的最大吸附容量为117 mg·g-1.(pH 7和303 K).HAP-Fe3O4-沸石复合材料对水中刚果红的吸附是自发吸热并伴随熵增加的过程.当pH为7时,HAP-Fe3O4-沸石复合材料吸附水中刚果红的主要机制包括表面配位作用、氢键作用以及路易斯酸碱反应.采用热再生的方法可以使吸附刚果红后的HAP-Fe3O4-沸石复合材料得到再生,热再生后的复合材料可以循环使用并且对水中刚果红的吸附性能良好.X射线衍射分析结果表明HAP-Fe3O4-沸石复合材料含Fe3O4,磁滞回线结果表明HAP-Fe3O4-沸石复合材料具备较高的磁饱和强度,复合材料吸附刚果红后可以很容易地通过外加磁场的作用快速地与水溶液分离.结果表明,HAP-Fe3O4-沸石复合材料适合作为一种吸附剂去除废水中的刚果红.     

K_2Cr_2O_7法和紫外分光光度法测定污水COD的对比研究

分别利用重铬酸钾法、重铬酸钾紫外分光光度法和紫外分光光度法测定污水的COD极差分别为2.43mg/L、1.19 mg/L和4.72 mg/L,RE%分别为0.84%、0.53%和1.36%,重铬酸钾紫外分光光度法和紫外分光光度法的线性范围分别在0~280 mg/L和0~400 mg/L.结果表明:重铬酸钾紫外分光光度法测定的准确度和精密度最高,简化了用标准溶液进行标定的步骤,缩短了实验时间;紫外分光光度法测定的结果准确度和精密度相对差一些,但是快速、操作简单、节省试剂,为广大环境工作者提供借鉴参考的实例。     

Formation of disinfection byproducts from accumulated soluble products of oleaginous microalga after chlorination

When microalgae are simultaneously applied for wastewater treatment and lipid production, soluble algal products (SAP) should be paid much attention, as they are important precursors for formation of disinfection byproducts (DBPs), which have potential risks for human health. Chlorella sp. HQ is an oleaginous microalga that can generate SAP during growth, especially in the exponential phase. This study investigated the contribution of SAP from Chlorella sp. HQ to DBP formation after chlorination. The predominant DBP precursors from SAP were identified with the 3D excitation-emission matrix fluorescence. After chlorination, a significant reduction was observed in the fluorescence intensity of five specific fluorescence regions, particularly aromatic proteins and soluble microbial by-product-like regions, accompanied with slight shifting of the peak. The produced DBPs were demonstrated to include trihalomethanes and haloacetic acids. As the algal cultivation time was extended in wastewater, the accumulated SAP strengthened the formation of DBPs. The trend for DBP formation was as follows: chloroform>dichloroacetic acid>trichloroacetic acid.

Open image in new window

     

China-Indian Silk Trade： Current Production and Future Prospects

As an important traditional labor-intensive industry of both India and China, the cocoon silk industry has long made great contributions to the ecological environment protection, rural economic development and the increase in export income of both countries. India is not only a very important cocoon silk trading partner, but an important production competitor of China. In recent years, there has been a large increase in the production and trade of the cocoon silk between China and India; however, China relies heavily on Indian market, which leads to a tendency of further deterioration in the silk trade environment between both countries. The present article makes an empirical study of the cocoon silk resources of the two countries and the scale, product mix and market structure of China-Indian silk trade from 2001 to 2007. Overall silk trading volumes from China to India and market concentration rate are on the increase because of the superiority of Chinese cocoon silk production over that of India. Owing to scattered market share and export that mainly focused on raw materials product, there has been a phenomenon of price reduction and quantity increase. India carries out fierce competition with China in the international market and even imposes antidumping sanction on Chinese silk, which are key factors restricting further increase between China-India trade. Based on the abovementioned facts, the authors aim to put forward suggestions for steadily developing the production and trade of China＇s silk.     

A comparative study on milk packaging using life cycle assessment: from PA-PE-Al laminate and polyethylene in China

A Life Cycle Assessment (LCA) approach was used to compare the environmental impacts in the life cycle of two milk packaging systems, PA-PE-Al laminate—a laminated foil made from paper, polyethylene and aluminum foil—and polyethylene. The data for the mass, energy fluxes and environmental emissions were obtained from published literature and from site investigations, for the two systems being analyzed for environmental impacts. The application of LCA using Eco-Indicator 99 has made the comparison of the environmental impacts of the two milk packages possible. The results of this LCA study are discussed and the results reveal that the composite packaging has a slightly higher environmental impact than the plastic one. In addition, the environmental impact of raw material extraction is the highest in all of the life cycle stages except for disposal. The environmental impact of composite packaging mainly comes from the fossil fuels, land use and respiratory inorganics categories, while the plastic packaging mainly comes from the fossil fuels category. However, the composite packaging has a greater environmental impact because it has not been well recycled and reused. This environmental impact could be decreased by developing the technology to separate out polyethylene and aluminum from the packaging.     

MnxCe1-xO2／γ-Al2O3催化剂的制备及其催化甲苯的燃烧性能

以γ-Al2O3为载体，以MnxCe1-xO2为催化活性组分，采用浸渍法制备了一系列负载型MnxCe1-xO2／γ-Al2O3催化剂（x=0、0．2、0．4、0．6、0．8、0．9、1），在固定床反应器中评价了催化剂对甲苯的催化燃烧性能。结果表明，MnxCe1-xO2／γ-Al2O3催化剂的催化活性与催化剂的焙烧温度、活性组分MnxCe1-xO2的负载量以及Mn、Ce摩尔比有显著关系，其中焙烧温度550℃、负载量为20％、Mn、Ce摩尔比为4：1时，即MnxCe1-xO2／γ-Al2O3催化剂对甲苯的催化性能最佳，反应温度为180℃时，甲苯的转化率达到95％。并在连续100h的稳定性操作后，催化剂的活性基本无变化。采用XRD、BET以及SEM等分析测试手段对催化剂的结构以及表面进行了表征。     

Assessment of heavy metal pollution from a Fe-smelting plant in urban river sediments using environmental magnetic and geochemical methods

Environmental magnetic proxies provide a rapid means of assessing the degree of industrial heavy metal pollution in soils and sediments. To test the efficiency of magnetic methods for detecting contaminates from a Fe-smelting plant in Loudi City, Hunan Province (China) we investigated river sediments from Lianshui River. Both magnetic and non-magnetic (microscopic, chemical and statistical) methods were used to characterize these sediments. Anthropogenic heavy metals coexist with coarse-grained magnetic spherules. It can be demonstrated that the Pollution Load Index of industrial heavy metals (Fe, V, Cr, Mo, Zn, Pb, Cd, Cu) and the logarithm of saturation isothermal remanent magnetization, a proxy for magnetic concentration, are significantly correlated. The distribution heavy metal pollution in the Lianshui River is controlled by surface water transport and deposition. Our findings demonstrate that magnetic methods have a useful and practical application for detecting and mapping pollution in and around modern industrial cities.     

固定化生物活性炭纤维处理洗浴废水的研究

采用混凝-砂滤-固定化生物活性炭纤维的组合处理工艺来处理洗浴废水.利用聚合氯化铝和聚丙烯酰胺为混凝剂对废水进行混凝处理,之后将废水通入砂滤柱,废水在曝气池进行曝气后进入固定化生物活性炭纤维(IBACF)单元.IBACF固定化完成后,连续运行30 d,去除率稳定之后,处理后的浊度、LAS、S0D_(Mn)平均值分别为2.2NTU、0.12 mg·L~(-1)、2.33 mg·L~(-1),平均去除率分别为95.2%、94.7%、84.8%.经处理后的洗浴废水各项指标均可以达到生活饮用水卫生标准或城市供水水质标准,可以直接回用于洗浴用水和其他生活杂用水.     

钼矿区周边农田土壤中重金属污染状况的分析与评价

对钼矿区周边农田土壤重金属污染情况进行了详细研究.选择该矿区受污染农田土壤样本80个,采用HNO3-HF-HClO4混酸对土壤样品进行处理,运用欧共体参比司推荐的BCR三步连续提取法进行化学形态分析;使用等离子体发射光谱仪(ICP-AES)测定土壤样品中Mo、Pb、As、Hg、Cr、Cd、Zn、Cu、Ni的全量及各种化学形态的含量并进行评价,同时对矿区地下水进行分析;采用spas软件进行数据分析.结果表明,矿山周边农田土壤重金属主要污染物为Cd、Hg并伴有Cr污染;Nemerow综合指数6.81,综合评价结果为该区土壤已受严重污染;Cd与As污染来源基本相同,Cu、Ni、Zn污染来源基本相同,Hg有独立的污染来源;重金属中化学形态分布为残余态>有机结合态>氧化结合态>酸可提取态;重金属Cr及Hg的有效态比例较大,可能会影响农作物的正常生长;矿山周边农田土壤重金属污染的原因可能是污染地下水的浇灌,矿石的开采、运输和大气降尘等过程;有机农药及塑料农用制品的施用过程,自然成土、矿物的伴生及其转化等过程.